Problems that electric elevators are easy to present during the running-in period

We all know that no matter any equipment has a break-in period, the normal operation of the equipment is the guarantee for consumer work. So what are the common problems of electric elevators during the running-in period? The following editor gives you a detailed introduction.

1. Leakage of electric lift

Due to the hazards of loose parts, vibration and heat of the equipment, water leakage may occur at the airtightness of the equipment and the number of the three-way joint. Most of the defects in forging, consumer processing, etc. are not easily noticed. However, due to the vibration and impact of the work project, such defects will be exposed. The situation is water leakage.

2. Onset of loosening

The parts of the re-production processing assembly line of the electric elevator that have been used have geometric shapes and specifications errors. In the early stage of application, it is very easy to cause damage, vibration and other interchangeable loads, hazards of thermal elements, and rapid damage. The previously tightened parts are loose.

3. Many operating errors

Due to the lack of control over the structure and characteristics of the equipment, electric elevators are very prone to common faults and even safety accidents of mechanical equipment due to incorrect operation.

4. Poor smoothness

Because of the small gap between the newly assembled components of the electric elevator, the uniformity of the gap cannot be ensured due to assembly, etc., the smooth grease cannot produce a symmetrical moisturizing mask to prevent damage. Reduced the high efficiency of lubrication, and caused abnormal damage to the machine parts in the initial stage. When it is more serious, it will cause scratches and common problems on the friction surface.

In addition, due to the production, processing and installation elements of the service platform machinery and equipment components, the surface of the machinery and equipment is not lubricated, the total contact area is small, the total contact area is small, the load is uneven, and the equipment is damaged. During the entire operation of the machinery and equipment, the surface friction of the convex and concave components and the joints, metal material waste and the friction of the machinery and equipment twice accelerated the surface damage of the machinery and equipment parts. Therefore, the machinery and equipment of high-altitude operation vehicles such as electric lift platform vehicles will cause component damage during the understanding period, and the damage rate will be faster. At this time, assuming that the electric elevator is loaded, it may cause damage to the components and cause equipment failures.